THE SELECTION GUIDE
Choose by action, not by outline.
A longer tool does not necessarily hold a larger section. Look at tooth spacing, usable opening and the way each mechanism releases.
02 / THE SPACING LADDER
From separation to finishing.
| Construction | Useful detail | Choose it for |
|---|---|---|
| Wide-tooth | 6 mm tooth gaps | Larger sections; begin at the ends |
| Tail sectioning | 95 mm tapered tail | Parting and controlled finishing, not knots |
| Handle styling | 3 mm tooth gaps | A full grip for everyday dry styling |
| Pocket folding | 105 mm folded length | Shielding teeth inside a bag |
| Dual-density finishing | Fine and coarse tooth zones | Two spacing zones in one tool |
THE MECHANISM MATTERS
How does it close?
Curved interlocking teeth and a spring hinge. The Arc opens 45 mm. Gather a twist without forcing the hinge beyond its stop.
An ivory-coloured decorative top with spring grip jaws. Hold a small section and release the grip before repositioning; no universal holding capacity is promised.
Two elongated spring jaws for temporary sectioning. Each clip is 110 mm long; this is not the same grip as a claw.
Four flat 60 mm clips use a curved spring action. Secure small loose sections rather than forcing a large section inside.
A curved bridge and a separate 145 mm pin. Pass the pin through the opening and section; remove it before moving the slide.
Keep heat separate.
None of these tools is intended to be heated. Keep acetate, polyacetal and polypropylene clear of hot styling tools; wipe wooden parts rather than soaking. Dry steel springs and clasps after gentle cleaning.
Compare all 10 tools